|
Installation - Fitting your floor plinth |
The Floor Plinth is an 18mm wooden plate
that directly resembles the Wall Frame detailed previously.
Each floor plinth measures 100mm in depth and is sent
at a maximum size of 2600mm in length.
- Firstly measure the width between your strike
plates or between your skirting boards. This measurement
will need to be accurate for the sliding doors to
glide effectively.
- Using the floor plinth provided,
carefully mark the measurements from Step 1 and cut
to the appropriate size.
|
|
|
- Once cut use a piece of sand paper to clear any excess
from the edge
- Now your Floor Plinth is cut to size drill appropriate
holes spaced evenly at around 600 mm between each. Apply raw plugs
to the areas along the floor you wish to attach and offer the newly
cut floor plinth to the area you wish to fix. Using the screws provided
attach the floor plinth. Make sure that you check that everything is
level, using packing materials where necessary.
Previous: Fitting
the wall frames Next: Fitting
the bottom track
Return to installation home
page
|
|
|
|
